LM317T Voltage Regulator with Pass Transistor

1974 Super Beetle Wiring of old external regulator to new internal regulator on alternator.



http://www.youtube.com/watch?v=IbJn8HpDbRs&hl=en

Solution to a very hard to diagnose issue on a 99 Honda Civic. The issue can be found on any car and here is the solution. Here are the facts to help you diagnose if the below is the same for you: Battery - good and tested by autoparts store Alternator - good and tested by autoparts store (outputs 14v when car is running) When testing amperage from + battery post to + battery cable, NO current draw is found. The mystery here is why the battery is draining. Since no relay/circuit is showing a draw, the draw is occuring from wiring not included in the large harness that powers all of the components inside your car, and in the engine bay. The only cable that hooks up avoiding this is the cable that the alternator uses to charge the battery. With car engine off, Test the battery's voltage after charging and disconnecting the cable coming from the alternator. You should have over 12v. Keep the meter on the battery, and then reconnect the cable from the alternator. If the voltage drops, and keeps dropping over a period of minutes, you have a bad alternator. Even though it may charge, it has an internal short and needs to be REPLACED. I hope this helps everyone figure out this mystery issue that can occur from time to time.



http://www.youtube.com/watch?v=oHKUvB5oHIA&hl=en

www.mercedessource.com - As these old Mercedes approach 20+ years the brushes are wearing out and the alternators are failing. Many owners are having their expensive alternators replaced without knowing that it might just be the inexpensive voltage regulator mounted on the back on the alternator.



http://www.youtube.com/watch?v=WYvZRz5Truo&hl=en

The ATtiny43U is the new ultra low-voltage AVR microcontroller from Atmel: With a built-in boost regulator, this micro overcomes typical voltages of common battery technologies and is able to run off single battery cells, enabling design of smaller and lighter applications. www.atmel.com



http://www.youtube.com/watch?v=yZPRo0kIjvk&hl=en